Veranda 73014858 Instruction Manual download pdf

Reducing Fence Panels & Gates

Reducing the Height of Ready-To-Assemble Panels & Gates:

Cut boards and U-channels to desired height (Fig. 1).

To cut posts, measure the height of the new panel/picket (X). Add 3" to the panel/picket

height from the bottom of the bottom rail hole to the top of the post. Mark a line and cut

the post at the line (or as project requires) (Fig. 4).

NOTE:

For panels with 3 rails, reroute the bottom post hole to avoid having to

reroute both top holes instead.

If cutting the bottom of a post, do not add 3" to panel/picket height.

Creating an Angled Panel:

a. Keep in mind the top rail will be longer than the bottom rail due to the angle.

Make sure it is long enough to cover the width of the panel once the angled cut is made

NOTE:

• Cut the ends of the rails at an angle parallel with the post. (Fig. 2).

• Scalloped panels are numbered on the bottom of the boards. Write the board

number in marker above the cut line to avoid losing track of the numerical order

after cutting (Fig. 3).

b. The top post holes my need to be elongated to accept the top rail (start with small

increments to ensure a tight  t without an open gap).

c. Mark the boards with a chalk line to guide the angled cut.

d. Secure rails into route holes with one of the methods below:

Boards

Post

Rail

U-Channel

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Rail Clips

Rail Clip

Notches

Rail

1/2" Drill Hole

Post

2 or 2

⁄

⁄2⁄

Deck Screw

Custom Notches

Rail Notcher Tool

Top View

Rail

Rail Clips

#73014079

Rail

Screws

1 2

3" 1

Summary of Contents

Page 1 - 3"

Reducing Fence Panels & GatesReducing the Height of Ready-To-Assemble Panels & Gates:Cut boards and U-channels to desired height (Fig. 1).To c

Page 2

Reducing the Width of Ready-To-Assemble Panels & Gates:Simply remove boards from panel and cut rails to desired length (make sure rails are 3"

Comments to this Manuals

No comments

Veranda 73014858 Instruction Manual

Browse online or download Instruction Manual for Circular saws Veranda 73014858. Veranda 73014858 Instructions / Assembly User Manual

Summary of Contents

Comments to this Manuals